crmpicco
07-18-2007, 02:59 PM
Can anyone help with a persistent issue I am having with my Belkin 54g Wireless router?
The signal I am getting is terrible (really bad!), if I move 3/4 meters away from the router and into the next room with my laptop then the signal drops to Very Low or cuts off (as WinXP reports it).
I have been through all the procedures, firmware update, change the channel, change positioning with Belkin. They have even sent me a replacement router - completely brand new one. The problem still persists. I can't seem to get a way around this one.
I've had a reply on another forum (http://www.codingforums.com/showthread.php?t=115287) stating that my walls could be made out of lead. However, the previous owner had wireless in the room I am trying to work in and i'm sure they would put up with terrible signal and bad speeds. The property is 50 years old and don't know what the walls are made out of.
Is there anything else I can try to remedy?
Picco
The signal I am getting is terrible (really bad!), if I move 3/4 meters away from the router and into the next room with my laptop then the signal drops to Very Low or cuts off (as WinXP reports it).
I have been through all the procedures, firmware update, change the channel, change positioning with Belkin. They have even sent me a replacement router - completely brand new one. The problem still persists. I can't seem to get a way around this one.
I've had a reply on another forum (http://www.codingforums.com/showthread.php?t=115287) stating that my walls could be made out of lead. However, the previous owner had wireless in the room I am trying to work in and i'm sure they would put up with terrible signal and bad speeds. The property is 50 years old and don't know what the walls are made out of.
Is there anything else I can try to remedy?
Picco