OBP
07-13-2017, 01:31 PM
When designing a Form I have found that the maximum form width is 22" or aroung 58cm.
However when you change a form to Datasheet or Split form mode the width is greater than 22" by around 6".
But if you now use the Datasheet Form as a Subform it is restricted once again to 22" and does not display about 6" of data that was available as a Datasheet.
How can Access display the form in Datasheet mode or the lower datasheet section in Split Mode wider than the form maximum when it is a standalone form?
However when you change a form to Datasheet or Split form mode the width is greater than 22" by around 6".
But if you now use the Datasheet Form as a Subform it is restricted once again to 22" and does not display about 6" of data that was available as a Datasheet.
How can Access display the form in Datasheet mode or the lower datasheet section in Split Mode wider than the form maximum when it is a standalone form?