aussie bar wanted me to put a link to the site where i had out the same question
BTW i already closed the question yesterday there.
aussie bar wanted me to put a link to the site where i had out the same question
BTW i already closed the question yesterday there.
When you posted the question on the other site you inferred you were not getting anywhere, yet clearly XLD had been assisting you.
I'm not sure that your credabilty is being enhanced here.
Remember To Do the Following....
Use [Code].... [/Code] tags when posting code to the thread.
Mark your thread as Solved if satisfied by using the Thread Tools options.
If posting the same issue to another forum please show the link
i just copied and pasted my question:when i posted the question it was AT the same time in both places:lets be clear.
my last post at stackoverflow was my answer and i closed that thread
When you post a thread here ( and I'm assuming anywhere else for this intent) please allow some time for forum members to respond. Posting the same question "at the same time" on multiple forums is disrespectful to those members operating in the forums. You need to remember that all persons operating here do so on a voluntary basis and as such if you lose their respect for you then getting further assistance may well be near impossible.
I also cannot over emphasis the need to post the cross link. If you post on multiple forums with the same issue, we need to be able to see if a solution ( or a pathway to a solution) has been found before we provide assistance.
Further more the solution you were provided with here by XLD, was posted in the other forum and does not give XLD any credit for the work he did.
I urge you to give this advice strong consideration before you post here again.
Remember To Do the Following....
Use [Code].... [/Code] tags when posting code to the thread.
Mark your thread as Solved if satisfied by using the Thread Tools options.
If posting the same issue to another forum please show the link