Calendar control not working

[Ken Puls]

Nice! Seems to have the issues I've ecountered.

Question though... I was sort of expecting that when I clicked "find today" it would actually set the value to today's date (and therefore highlight it) instead of just activating that month. Just a preference issue, but curious to know you're thoughts there.

Also, in a perfect world, the two routines: returnDate and returnCodes would be in the userform code somewhere. You'd then be able to just drop the userform into your project and code a one/two liner from another module to show it. I did try throwing them in with the userform code, though, and it didn't seem to work quite right. That was the last version though...

[BlueCactus]

Question though... I was sort of expecting that when I clicked "find today" it would actually set the value to today's date (and therefore highlight it) instead of just activating that month. Just a preference issue, but curious to know you're thoughts there.

Yeah, I've thought about it, and decided that I don't want to do it that way. My primary motivation for including it was to have a 'quick return' if you get off into the depths of time travel. If you want to implement it yourself, then place the following line after the canUpdate decrement in CommandButton2_Click:
[vba] Call SetNewDate(DatePart("d", Date))[/vba]

Also, in a perfect world, the two routines: returnDate and returnCodes would be in the userform code somewhere. You'd then be able to just drop the userform into your project and code a one/two liner from another module to show it. I did try throwing them in with the userform code, though, and it didn't seem to work quite right. That was the last version though...

The reason I did it this way was to avoid declaring the variables as public. But yeah, it has the potential to be a bit of a pain. I could probably at least combine returnDate and returnCodes into one Sub. Maybe have two routines. i) The equivalent of test() ii) Combination of returnDate and returnCodes. Drop both in at the end of a module, and use something like newDate = testEquiv(dpMode, etc, etc) from the calling code.

[Richardall]

Especially BlueCactus.

The document is complete with the needed code for the calendar.

Should I mark the thread closed???? It appears to still be getting a lot of usefull comments and suggestions. I wouldn't want to close out anything that was still usefull.

Admin, please advise.

Richard