Solved: Characteristics of an AutoShape Connector

[Cyberdude]

There is an AutoShape called a connector. It is basically a line with a small circle on each end. I would like to use it at times to connect two objects on a chart and have the ends attached to the objects it is connecting, so that if one or both of the connected objects moves, then the connector would stretch or contract to accommodate that movement and still remain connected. That doesn't seem to happen. The connector doesn't actually "connect". I have a feeling that it's supposed to and that I have to do something to make it happen. What must I do?

Later: Never mind . . . I figured it out. Gotta do a lot of clicking here and there.