Okay,

A typical field day:

P20 - Station setup
If it is a known station, it will have a code of "0=P20.1"
For a resection station the code will be "0=P20.2"
Each of these will obviously have different codes and label output.

P23 - Set-out: Look for marks and/or set-out points - Once again, different code arrangement depending on which one you are doing.

P24 - Set-out or record a point along a line.

P2 - Record detail/level points.

P30 - Establish a new station


Each of the above programs record redundant information by recording the station and back-sight information again when activated.

I could separate each field file in accordance with each program, but I would rather not do this.


The way I see it is that there about say 10 or less pointer codes to determine the program looping.

Perhaps we could start with P2 (Detail survey) and move forward from there.

Kind Regards,

Wooli